The Problems That the Users Should Pay Attention to | Internet and ...

Businesses Online | Internet and Businesses Online | * Written by Samantha | Sunday, 26 August 2012 23:58 | Word Count: 421

Ball mill is the key equipment for grinding after the crushing process, which is widely used in the manufacture industries, such as cement, silicate, new building material, refractory material, fertilizer, ferrous metal, nonferrous metal and glass ceramics and can be used for the dry and wet grinding for all kinds of ores and other grind-able materials.1. When ore-machine.com/ball-mill.html">ball mills are running, regularly loud hit sound comes from the machine, the reason is some liner bolts is loosen. You can judge the position of liner bolt based on the sound resource, and then find it and tight it up.
2. The temperature of ball mills and motor bearing is rising and exceeds regulation. In this case, you can touch the machine to judge the heated parts are over whole or just partly. Settle the problems with these methods as follows.
(1) Check all the lubricating points, if the using oil specifications are complies with equipment instructions or not.
(2) Check if the lubricating oil and grease becomes bad.
(3) Check if lubricating road is clogged, and if lubricating oil directly enters into lubricating point. Oil shortage will cause machine overheated.
(4) Side gap between ball mills and bearing bush is too small, and the gap of bearing bush and bearing is too large. As a result, the contact points are too much to form evenly oil film on the bush.
(5) The reason can also be the amount of roller bearing lubricating oil is too much or too little. Too much amount oil will generate heat and hardly dissipated. Too little oil will cause poor lubrication. So, we should add enough oil as regulation, generally the amount is 1/3~1/2 of the bearing gap.
(6) Two ends of ball mills body is too tight in sealing, or sealing body contact directly with bearing, can cause overheated.
All the above problems should be solved according to different reason.
3. Ball mills reducer bearing overheat
Except checking it according to ball mill heating check methods, we should check gas discharging port of reducer. If it is clogging, we should keep it clear.
4. Ball mills vibrates when motor starts reducer, the main reasons are:
(1) The gap of connected two wheels is too small, as a result, it can?t compensate driving power.
(2) The method of shaft coupling correcting is not right, which leads to unconcentric of two bearings.
(3) The connecting bolt of shaft coupling is not fixed tight equally, and the tight degree is different.
(4) Ball mill bearing outer ring is flexible.
Settlement: adjust gap of two wheels as instruction statement, and make them concentric. Fix tight the connected bolts with equal force.

?

0

Article Source: Article Directory - http://www.freearticleforyou.com

15

Additional Information on Author

Author of this article: Samantha.

Number of Articles Published: 22

View Authors profile

Samantha joined FAFY - Free Article For You on Saturday, 11 August 2012.

Additional Articles

Re-Publish: The Problems That the Users Should Pay Attention to

You have permission to re-publish this article electronically or in print, as long as you are able to follow the Publishers Guidelines.

Source: http://www.freearticleforyou.com/Businesses-Online/Internet-and-Businesses-Online/the-problems-that-the-users-should-pay-attention-to.html

michelle malkin october baby sugarland 16 and pregnant ludwig mies van der rohe jamie lynn sigler